|
|
| Vertical Press Systems |
|
| Press Gallery |
Two Platen Press
|
| This press was designed for a manufacturer of headliners for the automotive industry. The press features two platens. The lower platen extends to a preset position and holds. The upper platen advances at fast speeds to a preset position and switches to press speed. The part is contacted and held under pressure until a dwell timer times out to signal the upper platen to return. The lower platen retracts when the upper platen reaches its full up position. To assist die removal the two platens and bed are sculpted. The press also includes a fabricated bolster.
|
| |
Specifications
|
|
| Capacity |
200 Tons |
| Stroke of Upper Platen (Adjustable) |
36 Inches |
| Stroke of Lower Platen (Adjustable) |
18 Inches |
| Daylight |
87 Inches |
| Between Rods, Left to Right |
140 Inches |
| Between Rods, Front to Back |
94 Inches |
| Lower Platen to Floor |
68 Inches |
Cylinder size (2) 7" diameter bore 5" diameter rod
Two air operated saw tooth platen latches
One interlocking swing in safety bar
Position repeatability of both platens ± .050 |
|
| Motor |
75/HP
1800 RPM |
| Speeds approximate (Both Platens) |
|
| Advance Speed |
634 In/Min |
| Press Speed (Adjustable) |
59 In/Min |
| Return Speed |
660 In/Min |
|
|
| |
 |
| Two Platen Press
|
|
|
|
|
|
|
|
Clamp
Services
